FLEX-C2 is a high-performance, cement-based tile adhesive with extended open time, designed for all types of tiles, including fully vitrified and large-format tiles. Suitable for both walls and floors in interior and exterior applications, it is especially recommended for facades. Exceeding the requirements of EN 12004, FLEX-C2 is classified as C2TE, ensuring superior strength and reliability.
For all type of masonry substrates such as sand/cement render, precast concrete, gypsum board, sound painted
walls, where an extended open time is required.
For installation of ceramic and porcelain tiles.
Over Tiles. Tile on Tile application.
For residential, commercial and industrial purpose, swimming-pools, facades, bathrooms, balconies, terraces and
parking areas.
The substrate should be sound, clean, free from loose material, grease, dirt or any other substance that might impair bond quality with the substrate. Concrete, hollow blocks, and cement-based substrates must be sufficiently cured. The surface should appear damp with no water pooling. Gypsum boards, plasterboards, anhydrite screeds must be sufficiently dry and free from dust.
MIXING
Mix 20kg FLEX C2 with 5-6 liters of clean cool water (3:1 ratio) until a smooth, lump-free paste is obtained. Leave the paste to rest approximately 5 minutes before starting the application.
Technical Data
Product Name
Typical Values
Appearance
White or grey
Application Thickness
2 to 8 mm
Pot Life
60 mins
Mixing ratio
30 parts water for every 100 parts of tile adhesive.
Open time
≥ 30mins
Adjustability time
Approx. 30mins
EN 12004 Classification
C2TE
APPLICATION
Apply the tile adhesive to the substrate using a notched trowel. Choose a trowel that gives the correct coverage to the
tile. To achieve good adhesion, spread an initial thin layer of adhesive on the substrate using the flat side of the trowel.
Comb the adhesive with a suitable notched trowel horizontally to achieve a 2 – 6 mm bed thickness. Spread the mortar
adhesive to a manageable area that can be tiled within 5-10 minutes. Press the tiles firmly over the mortar adhesive and
immediately knock them into the desired position. Adjust the position of the tiles, if required, within its adjustability time
after installation.
Use the back buttering method for large format tile applications. Apply and comb the adhesive on the surface to be tiled.
Also, add the adhesive to the backside of the tile with/without combing.
Note:
Use the back buttering method for large format tile applications. Apply and comb the adhesive on the surface to be tiled. Also, add the adhesive to the backside of the tile with/without combing.
PRECAUTIONS AND SAFETY MEASURES
This product contains Portland cement which is slightly alkaline when wet. For people with sensitive skin, continuous use
may cause irritation. Gloves or a suitable barrier cream should be used. As a general Code of safety practice all
chemical products should be treated with care, kept away from children and animals, especially protect eyes and skin.
In emergency seek medical advice.
Packaging
20/kg
Storage and Shelf Life
FLEX C-2 may be stored for up to 12 months in its original packaging in a dry shaded place.
Reviews
There are no reviews yet.
Be the first to review “FLEX – C 2 – Sea Star Tile Bond”Cancel Reply
Reviews
There are no reviews yet.